The Fluke 2052 advanced cable locator accurately and safely troubleshoots live and de-energised cables in residential, commercial and industrial environments up to CAT IV 600 V. This CAT specification offers the highest protection available on any cable locator. It is designed to protect you from the most dangerous levels of commutation collapse, peaks up to 8,000 V, that can occur in industrial environments. This is especially important for scenarios you may encounter in environments such as industrial plants, factories and hospitals where critical equipment cannot be taken out of service.<\/p>\n
Whether troubleshooting electrical wiring and equipment in homes, commercial buildings or high-voltage facilities, the Fluke 2052 can easily detect breaks, interruptions and short circuits. Its various modes and functions give you the flexibility to detect a wide range of electrical wiring and circuit problems you may encounter on the job.<\/p>\n
The 2052-R receiver detects signal in wires and cables in two ways: passive tracing without transmitter for non-contact voltage detection, and active tracing with transmitter for all other modes. The receiver's point sensor can trace wires in corners, tight spaces and junction boxes.<\/p>\n
The 2000-T transmitter operates on live and de-energised circuits up to CAT IV 600 V and has high, low and loop modes. These modes change the strength of the generated signal and, depending on the circuit you are tracing, can provide more accurate results.<\/p>\n
The 2000-T automatically detects whether the system is energised or de-energised and selects an output frequency of 6 kHz or 33 kHz.<\/p>\n
More sensitivity levels mean more flexibility and tracking accuracy.<\/p>\n
The Fluke 2052 advanced cable locator kit comes with everything needed to start tracing wires and circuits. The accessory kit includes test leads, test probes, adapters for wall sockets with round and flat pins and alligator clips to connect the transmitter to electrical systems. Connecting the transmitter to a bare conductor with the crocodile clips and test leads provided always gives the most accurate results. However, in situations where a direct connection to a bare conductor is not available, the supplied i400 current clamp can be used with the \u2018Loop\u2019 mode to generate an amplified 6 kHz signal through the insulation. The kit also includes batteries and a hard carrying case.<\/p>","protected":false},"excerpt":{"rendered":"